From Profile refrigerators to front-load washers, our technicians know GE's motors, sensors and control boards. We diagnose the fault, quote it upfront, and carry the parts Okanagan homes need most.
We repair GE appliances to the manufacturer's own specs, not guesswork.
Most GE repairs are wrapped up the same day across Kelowna and Vernon.
Every GE repair is backed by our 90-day workmanship warranty.
We fit genuine GE parts so your appliance keeps running right.
GE models we service
GE Refrigerator Repair
French door, side-by-side, Profile
GE Washer Repair
Top-load & front-load
GE Dryer Repair
Electric & gas
GE Dishwasher Repair
Built-in, Dry Boost
GE Oven Repair
Wall & built-in, convection
GE Stove Repair
Gas, electric & induction
Service area
Our mobile GE service reaches both Okanagan cities. Pick yours for the areas we cover.
Actual GE repairs finished for Kelowna and Vernon homes.
$180Loads came out sopping. The drive belt had stretched and the lid switch was intermittent; we replaced both and the spin cycle is back to full speed.
$170Dry Boost wasn't boosting — dishes stayed wet. The vent flap had stuck and the element was weak, so we renewed both and confirmed a proper dry.
$215One element wouldn't heat at all. Behind it sat a burnt terminal block; we replaced the block and the element, and every ring heats evenly now.
Prices shown are the total charged for that specific job and are for reference only. Your quote is confirmed on site before any work begins.
Call and book a diagnostic for your GE appliance today at (250) 900-3425.
The GE faults our technicians run into over and over.
Usually it's a worn coupling, lid switch or suspension. We fit the parts needed to get the drum spinning again.
A tired fan, damper or sealed-system part lets the cold drift. We pin it down and get steady cooling back.
Laundry finishes damp when the heating circuit gives out. We check the element and controls and bring the heat back.
A worn heating element or blocked vent leaves dishes wet even on Dry Boost. We replace it so they finish dry.
An F code usually traces back to the oven sensor or control board. We read it, fit the part, and confirm the oven holds heat.
A failed element or terminal block leaves one ring cold. We replace it so every burner heats the same.
Fault guide
GE ranges and ovens show 'F' codes, while GE washers and dishwashers usually flash lights instead of a code. Here's what each of those signals is telling you. Letting us know the symptom when you book means we show up with the right part.
Running too hot
Over-temperature — a sensor or relay fault.
Sensor open
The oven temperature sensor circuit is open.
Sensor shorted
The oven temperature sensor has shorted out.
Key stuck
A button on the control panel is stuck.
Door lock fault
A problem with the door latch or lock motor.
No water coming in
Inlet valve, float switch or the supply itself.
Water left behind
Drain pump, filter or hose is blocked.
Water on the floor
Door seal, a hose or a pump gasket has gone.
Cycle won't begin
Door latch, control lock or the main board.
Poor drying
The heating element or vent needs attention.
Load stays soaked
Motor coupling, lid switch or drive belt.
Shakes then stops
Worn suspension or an unevenly loaded drum.
Water in the drum
The drain pump or hose is blocked.
Little or no water
Inlet valve or the water-level sensor.
Lid won't lock
The lid lock assembly or switch has failed.
GE fault codes and blinking-light patterns differ from one series and model year to the next. Not sure what's going on? Call with your model number and we'll help you make sense of it.
Here's how we bring your GE appliance back to life.
Give us a call or fill in the form. We take the details and lock in a time that suits you.
Your technician arrives inside the window, van loaded with the GE parts these jobs usually call for.
We find the real cause, explain it in plain words, and set the price before anything gets touched.
We carry out the fix, run the GE appliance to be sure it works, and leave the space clean.
Tell us the model and what it's doing. We'll confirm a same-day or next-day visit across Kelowna and Vernon.
Tell us what's wrong and we'll call you back to confirm a time.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Your request has been sent. We'll get back to you shortly.
Prefer to talk it through?
(250) 900-3425